iRobot Roomba 690Roomba error 10Roomba error 10 — cause and how to fix it
Error code: Roomba error 10
Error 10 on your Roomba 690 usually means the bin is full or there's a blockage in the suction path.
How to fix Roomba 690 Roomba error 10
- 1
First, take out the dustbin and empty it.
- 2
Then, check the intake area where the dirt enters the bin for any tangled hair or debris.
- 3
You might need to remove the brushes and clean under them, as hair can wrap around the brush bearings and block airflow.
- 4
A new replacement filter and brush set can usually be found for $15-25 on Amazon.
What this repair uses
Roomba 600 series replacement filter and brush kit
Take it out, clean it, and seat it again before you replace it. If the error stays, this is the part to change.
Frequently asked questions
What does iRobot Roomba 690 Roomba error 10 mean?
Error 10 on your Roomba 690 usually means the bin is full or there's a blockage in the suction path.
Is this a hard repair to do myself?
Most of the steps above take 20-40 minutes with basic tools like a screwdriver. If you'd rather not open the unit yourself, contact the official support line below instead.
What part do I need?
You'll need a Roomba 600 series replacement filter and brush kit. Compatible aftermarket parts are widely available on AliExpress and typically cost $8-60 depending on the part.
How do I contact iRobot support?
Register your Roomba on the iRobot app before contacting support — this speeds up warranty claims significantly. Phone: 1-800-727-9077
Official support
Register your Roomba on the iRobot app before contacting support — this speeds up warranty claims significantly.
Online support
Open support page →