iRobot Roomba 890Roomba Error 10Roomba Error 10 — cause and how to fix it
Error code: Roomba Error 10
This 'Error 10' on your Roomba 890 usually means there's an issue with the dustbin or the brush system.
How to fix Roomba 890 Roomba Error 10
- 1
Often, debris gets packed tightly around the main brush bearings, preventing them from spinning freely.
- 2
To fix this, remove the dustbin and then carefully detach the main brush assembly.
- 3
Clean out any hair, dust, or debris, paying close attention to the ends where the brushes connect.
- 4
A replacement brush module assembly for the Roomba 800 series can be found on sites like Amazon for around $20-35.
What this repair uses
Roomba 800 series main brush module
Take it out, clean it, and seat it again before you replace it. If the error stays, this is the part to change.
Frequently asked questions
What does iRobot Roomba 890 Roomba Error 10 mean?
This 'Error 10' on your Roomba 890 usually means there's an issue with the dustbin or the brush system.
Is this a hard repair to do myself?
Most of the steps above take 20-40 minutes with basic tools like a screwdriver. If you'd rather not open the unit yourself, contact the official support line below instead.
What part do I need?
You'll need a Roomba 800 series main brush module. Compatible aftermarket parts are widely available on AliExpress and typically cost $8-60 depending on the part.
How do I contact iRobot support?
Register your Roomba on the iRobot app before contacting support — this speeds up warranty claims significantly. Phone: 1-800-727-9077
Official support
Register your Roomba on the iRobot app before contacting support — this speeds up warranty claims significantly.
Online support
Open support page →